Vehicle specific fender flares - 2 pieces - 25mm wide - suitable for Fiat Ducato (2006-)
- The extensions are glued to the fender edge (outside and inside) of the bodywork
- An additional screw connection is possible
- Cost-effective, flexible and therefore almost indestructible rubber fender flares
- the fender flares are not paintable
- optimal e.g. for track widening with spacers or wider tires & rims
Vehicle specific fender flares - 2 pieces - 25mm wide - suitable for Fiat Ducato (2006-)
Scope of delivery:
-2 pieces (2x length 1430 mm)
-Can be used for the front or rear axle
-25 mm (the vehicle is widened by 25 mm per mudguard / 50 mm per axle).
-TÜV Süd test report (TÜV-Süd, Westendstr. 199, 80686 Munich, test report 16-00074-CP-BWG)
Can be used:
For vehicles without additional plastic fender flares
TÜV registration:
You will receive a TÜV Süd test report from us with the delivery of the fender flares. The registration of the fender flares is not necessary, this is also stated in the report, however, we know from experience and from many customer messages that the regulatory authorities like to see such a TÜV confirmation again. Only then will there really be no trouble with the inspection service and therefore we have had a TÜV Süd report drawn up.
Suitable for the following vehicle:
Manufacturer: Fiat
Designation: Ducato
Type: 250
Year of construction: 2006-
Installation:
-the ambient temperature and the temperature of the components or mounting surface must be at least 20° Celsius during installation and for at least 24 hours afterwards
-the surfaces on the vehicle for installation must be rust-free, smooth, thoroughly cleaned and free of grease
-after removing the backing film, the fender flares must be pressed against the surface for approx. 1 minute with high and even pressure
-the ends of the fender extensions can be adapted to the vehicle's appearance using a sharp carpet knife
-We recommend leaving the vehicle for at least 6 hours after installation
-the final strength of the adhesive joints is only achieved after 48 hours
-Please do not wash the vehicle for at least 48 hours
-for some widths, some mounting situations, structured surfaces or if the mounting instructions cannot be followed, additional fastening with e.g. self-tapping screws or body adhesive is required
We have been offering off-road accessories with service and headquarters in Germany for 40 years. Ask us to find out more about our products. We will be happy to help you.
Hansen Styling Parts e.Kfm.
Dorfstr. 9
DE-24247 Mielkendorf
WEEE-Reg.-Nr.: DE31112252
Tel.Nr.: +49 4347 706970
E-Mail: [email protected]
Internet: www.hansen-styling-parts.de
Matching items
